The Atmel JTAGICE3 is a powerful development tool for debugging and programming ARM® Cortex®-M based Atmel® SAM and Atmel AVR® microcrontrollers with On-Chip Debug capability.
• Programming and on-chip debugging of all Atmel AVR 32-bit Microcontrollers on both JTAG and aWire interfaces
• Programming and on-chip debugging of all Atmel AVR XMEGA® 8-bit Microcontroller Family devices on both JTAG and PDI 2-wire interfaces
• Programming (JTAG, SPI, and UPDI) and debugging of all Atmel AVR 8-bit Microcontrollers with OCD support on JTAG, debugWIRE, or UPDI interfaces
• Programming and debugging of all Atmel SAM ARM Cortex-M based microcontrollers on both SWD and JTAG interfaces (firmware version 3.0 and later)
Atmel JTAGICE3 Features • Fully compatible with Atmel Studio
• Supports programming and debugging of all Atmel AVR UC3 32-bit microcontrollers
• Supports programming and debugging of all 8-bit AVR XMEGA devices
• Supports programming and debugging of all 8-bit Atmel megaAVR and tinyAVR devices with OCD
• Supports programming and debugging of all SAM ARM Cortex-M based microcontrollers
• Target operating voltage range of 1.65V to 5.5V • Draws less than 3mA from target VTref during operation
• Supports JTAG clock frequencies from 32kHz to 15MHz • Supports PDI clock frequencies from 32kHz to 10MHz
• Supports debugWIRE baud rates from 4kbit/s to 0.5Mbit/s • Supports aWire baud rates from 7.5kbit/s to 7.5Mbit/s
• Supports SPI clock frequencies from 8kHz to 1.875MHz • Supports UPDI baud rates from up to 750kbit/s
• Supports SWD clock frequencies from 32kHz to 2MHz • USB 2.0 high-speed host interface
• ITM serial trace capture at up to 1MB/s
• Supports 10-pin 50-mil JTAG connector, as well as 10-pin 100mil JTAG, 6-pin 50-mil SPI, and 6-pin 100-mil SPI interfaces using adapters
Oryginalny produkt Atmel'a. Stan idealny. Gwarancja uruchomieniowa.