Real photos:
ujeb.se/2TMWs
ujeb.se/DjQ12
http://ujeb.se/IOANR
Zasilacz oraz kabel jack-jack w zestawie
Stan:Nowy
Nadajnik na pasmo radiowe 76-108MHz z regulacją kroku co 0.1MHz.
Moc regulowana od 1W do 30W z krokiem co 1W
Miernik SWR na ekranie w czasie rzeczywistym.
Zasilanie 12V DC
Wejście Line IN i Microphone: Jack
Demonstracja działania:
https://www.youtube.com/watch?v=l84aCG7SQ6M
https://www.youtube.com/watch?v=zLyeq49oSK4
https://youtu.be/zUy6b 2gYOw
https://www.youtube.com/watch?v=uuTnc9E2SZE
https://www.youtube.com/watch?v=JAO4BmVsbPM
https://www.youtube.com/watch?v=OOsGgG283CM
https://www.youtube.com/watch?v=k42qY4L7bxI
,Operating instructions
A , frequency adjustment: Press the middle button for more than 5
seconds. The system then enters the interface to set parameters.
When the ‘FRE’ appears on the single screen, the frequency value
can be modified by pressing the UP key or Down key. The long
press KEY can adjust the frequency value quickly. After adjusting
the parameters, you can switch parameters or exit adjustment mode
according to the middle button.
B , Power adjustment: Press the middle button for more than 5
seconds. The system then enters the interface to set parameters.
When the ‘PO’ appears on the single screen, the frequency value
can be modified by pressing the UP key or Down key. After
DC12V
The power input
Rf output
The output
impedance is 50 ohms
UP KEY
Middle KEY
Down KEY
Microphone input
Audio input
USB disk input
adjusting the parameters, you can switch parameters or exit
adjustment mode according to the middle button.
C , Volume adjustment: Press the middle button for more than 5
seconds. The system then enters the interface to set parameters.
When the ‘VOL’ appears on the single screen, the frequency value
can be modified by pressing the UP key or Down key. After
adjusting the parameters, you can switch parameters or exit
adjustment mode according to the middle button.
D , Player adjustment: When the system is not in the parameter
adjustment interface, press UP KEY or DOWN KEY to switch the
PREV or the next, and then play/pause the button in the middle
KEY.
2, Precautions for use:
A, The power supply is dc voltage. The input is positive and negative. The
voltage input range is 12-13v. The input ability of the power supply must not be
less than 8 amperes.
B, Antennas must be used to transmit antennas of 50 ohms. The
frequency range needs to be between 76-108MHZ. Note that the standing
wave ratio on the display should not be greater than 2.00 when used.
3:Parameter description
1, input voltage: DC 12V-13.5V can not exceed 13.5V power supply.
2,input current: <7A
3,audio signal: the maximum input Vpp is less than 1V.
4 ,microphone type: cylinder microphone or microphone!
5, output power: 30W, peak power can reach 40W
6, output impedance: 50
7, working frequency: 76M-108MHz
8, frequency step: 0.1MHz
9, distortion: 0.03% ~ 0.1%
A, board size: Launch plate: 150 * 80mm (excluding SMA and other prominent parts), height
70mm (excluding display part)
B, launch distance: greater than 8KM (the premise is that the open area, the antenna height is
high enough)
4 ,Interface sketch