235X235mm Double Sided Textured PEI Spring Steel Sheet for Ender 5
Description:
No more Masking tape,no more ,no more ABS juice,no more PEI sheet replacement.
Easy to print,easy to remove by bending and popping it off,easy to maintain.
Double-sided
Lower runing cost especially for printing farm
PEI
Hardened steel spring sheet never diforming
Make adding inductive possible
Possible to adding ABL for some low-cost
Fit for Anet A8 A6 I3 Ender 5, with installation, bed size with Base.
Specification:
Material Compatibility:PLA ABS PETG TPU PVA etc.
Size Chart:
Size:Approx.235X235mm/9. .3inch
Package Includes:
1 Piece steel sheet
1 Piece B plate sheet
Note:
Wipe the print surface a print with isopropyl alcohol
to maintain a clean surface for maximum bed adhesion strength. As with
surface, make sure you are not printing too close to the bed
to avoid possibly infusing the filament into the build surface. If
printing PETG, TPU, TPE, and , make sure the bed is heated BEFORE
attempting to remove the print from the bed.
B plate with adhesive, stick on the build surface.
Please Kindly Note: the plate is , the temperature (recommended
to 80 degrees centigrade) should not exceed 80 degrees. so It
is not suitable for ABS . if set heated more than 80 degree, it 's
magnetism will be weaker.